>

SOFT START DUAL O2 EFIE WITH BOX…

O2 EFIE ADD VOLTAGE SIMULATION…

I’ve been getting back into HHO and wanted to show the new stuff we’ve been working with- It should work really well!…

WWW.HHOGASSAVER.COM Tri EFIE Two O2 Sensor and One Map Sensor Enhancer for use with HHO Gas…

This is my HHO injection setup. To retard timing, a lot of people suggest putting a 10k ohm resistor in parallel with the IAT sensor. Istead of tricking the ECU, why not just feed in warmer air. Temp usually gets to 125. That’s what I did. All I did was modify the air intake filter [...]

MY DUMB VIDEO. this is an EFIE that was designed by the mad scientist 67 he has designed it to be simple but affective. the one you are looking at was assembled by me using his plans. he is sharing his info free of charge on his website, madcosm.com/index.htm this is very easy to build, [...]

I WANT TO MAKE SURE EVERYONE UNDERSTANDS THAT THIS PLASTIC PAINT CAN IS NOT TO BE USED WITH SUCTION OF THE CAR. THE PLASTIC PAINT CAN IS FOR EXPERIMENTAL PURPOSES ONLY. THIS IS JUST MY EXPERIMENTAL ELECTROLYSER NOT BAD FOR MY SECOND TIME. I JUST FOUND OUT HOW TO LEAN MY FUEL RATIO. I [...]

twin cell electrolizers in series with maf sensor enhanced yielded over 37% improvement in fuel economy….

Initial test results look good! I have it set to max, that is, 250mV. I plan to build one more and combine the 2 circuits, add the delay timer, change the pin connections to allow 50 - 300mV(instead of 0 - 250mV), and use a relay instead of a switch….

Shows how EFIE Oxygen Sensor Enhancer behaves. This device will help to lean out air/fuel mixture and will improve mileage gains for your vehicle. It adds a small offset voltage to the existing Oxygen Sensor signals going to the vehicle’s computer (ECU). The device is to be used in conjunction with hydrogen electrolyzer or [...]